Herramientas y suministros

Seleccionar Imagen N.° de pieza
 Fabricante:
Descripción Hoja de datos Disponibilidad Precio: (USD) Filtre los resultados en la tabla por precio unitario en función de su cantidad.
Cantidad RoHS
SparkFun Accesorios SparkFun Heat Sink Compound 20En existencias
80Se espera el 9/6/2026
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun 2x3 Pin Shrouded Header 41En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun This red Mini Breadboard is a great way to prototype your small projects! With 170 tie points there's just enough room to build and test simple circuits; They're also great for breaking out DIP package ICs to jumper wires! If you run out of room no 23En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun Stackable Header 2x23 Pin Female 232En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun This is a simple 2x3 male PTH header. This header is in the common configuration for an ISP connector. Each pin has a spacing of 0.1" in between each other.Documents:Datasheet 61En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun These stackable headers are made to work with the SparkFun ESP32 Thing Plus to connect to shield with a Feather footprint. This set includes one 12-pin and one 16-pin header; the pins are spaced by 0.1".Each set of headers allows you to stack Feather
Hoja de datos
21En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun Soldering Iron Stand 3En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun 2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. 4" long. Not sure which RF connector you need on your antenna? Check out our RF Connector Guide 3En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun 900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 105mm long. Be sure to pick the antenna with the right connector. Almost all 2.4GHz and 915MHz antennas need to be RP-SMA. 62En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This is a 4" connector cable that interfaces U.FL RF connectors to regular SMA connectors. This cable is commonly used to connect larger GPS antennas and quad-band cellular antennas. 86En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun This cute little coax is a champ in our RF kit! It has a right angle female U.FL (aka I-PEX) connector on both ends. Now instead of jerry-rigging a few U.FL to SMA cables together we can go straight from one U.FL device to another. As an added bonus
Hoja de datos
98En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun Rocker Switch SPST (right-angle) 59En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun This is a heavy duty SPST toggle switch - your basic on/off toggle. Rated for 2A at 250V or 4A at 125V. Includes a face plate and two threaded nuts for mounting. Works great with our missile switch cover. 7En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun The QRE1113 is a small IR reflectance sensor. This sensor is often used in line following robots because if it can sense if a surface is white or black.There are four pins on the QRE1113 - two control the IR emitting LED while the other two are the 15En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This is a simple LED-illuminated tactile button with a green cap. It's just like a basic tactile button but it lights up green! So now you can get visual feedback or light up your project. These have a 12mm body and are rated for 50mA. They don't e
Hoja de datos
13En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This 1024 pulse per rotation rotary encoder outputs gray code which you can interpret using a microcontroller and find out which direction the shaft is turning and by how much. This allows you to add feedback to motor control systems. Encoders of thi 3En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun It's the end of the world and you need a button to press. This is it. A 100mm diameter (outside diameter) dome illuminated push button comes with an LED securing nut and a pre-installed long life horizontal microswitch. Button can also be adjusted 1En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This is a single pole 10 position rotary switch able to select up to 10 different states in a durable package. Unlike our other rotary switch this model is much more robust and capable of handling larger currents and voltages. You may find this rot 17En existencias
140Se espera el 30/6/2026
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun Cherry MX Keyswitches are top-of-the-line mechanical keyboard switches. They re satisfyingly clicky reliable up to tens-of-millions of key presses and a standard in gaming and programming keyboards across the globe. This 'blue' version Cher 29En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun Amphenol FCI Clinchr Conn. (2 POS,M)
Hoja de datos
7En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun Break Away Male Headers Right Angle 10En existencias
Min.: 1
Mult.: 1

SparkFun Accesorios SparkFun This is a SparkFun exclusive! These are 12" long jumper wires terminated as male to male. Use these to jumper from any female header on any board. Multiple jumpers can be connected next to one another on a 0.1" header. Comes in one pack of ten jumper 8En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This is a right-angle 24-pin Molex Mini-Fit Jr. connector commonly used as the power supply connector on ATX motherboards. Two rows of twelve pins are broken out two rows of through-hole male headers. See the datasheet below for pin spacing dime 30En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This is a 3-pin through-hole PH series JST connector. The pins are spaced by 2mm.We really like the solid locking feeling and high current rating on these small connectors. This connector mates with our 3-pin jumper wire and may be useful for inter 17En existencias
Min.: 1
Mult.: 1
SparkFun Accesorios SparkFun This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST connector on one end bare cable on the opposite end. It also comes with the mating connector for the JST.
Hoja de datos
22En existencias
Min.: 1
Mult.: 1